WTS2 Stainless Steel Wire Wall Tie (250)

Product code: Select Options

Select Options
x
Turriff Depot1
Inverness Depot3
Dundee Depot8
From £76.50 (£63.75 +VAT)
Delivery Truck Logo

£6.95

Or Free Collection From Store

Strongtie, WTS Type 2 wall ties are suitable for general purpose applications such as domestic and small commercial buildings up to 15m in height.

They can also be used in buildings with heights exceeding 15m, but should only be used in those situations if shown to be of adequate performance by calculation.

Use in flat sites where the basic wind speed is up to 31 m/s and the altitude is not more than 150m above sea level.

Available in 3 sizes:

225mm
250mm
275mm

A datasheet can be downloaded via the link below.

WTS datasheet
  • Size
Size:Select

Quantity:

  • Installation:
  • For walls in which both leaves are 90mm or thicker, masonry ties need to be placed at not less than 2.5 per square metre (900mm horizontal x 450mm vertical centres).
  • The ties should be evenly distributed throughout the wall area, with the exception of around openings and should be staggered where possible.
  • Insulation Board:
  • Where insulation board is installed within the cavity and restrained by ties with insulation retaining clips (Simpson Strong-Tie ref. IRC001), it may be necessary to reduce the horizontal spacing of the ties to 600mm.
  • At vertical edges of an opening, unreturned or unbonded edges, and vertical expansion joints - additional ties should be used at a rate of one per 300mm (height) and located not more than 225mm from the edge.

Customer reviews


No customer reviews have been written for this product yet.

Request Quotation

Request Now
X
X